Startup, Installation, Wiring | Installation Environment

Avoid the following locations for installation.

Where the unit receives radiant heat from strong heat sources such as heat treatment furnaces
Where the ambient temperature exceeds the range of 0 to 40°C
Where the temperature changes rapidly and condensation occurs
Where the relative humidity exceeds 85% RH
Where the unit receives direct sunlight
Where the unit is exposed to corrosive or combustible gases
Where the ambient air contains a large amount of dust, salt or iron (at levels exceeding those typical of an assembly plant)
Where the unit is subject to splashed water or oil (including oil mist or cutting fluid) or chemical solutions
Where the body receives impact or vibration
Where the altitude is more than 1,000 m

Provide sufficient work space for the following maintenance and inspection:

Space to insert the teaching tool connector
Space to replenish grease
Space to replace the motor or controller
For details, refer to instruction manual for each ELECYLINDER .

If the unit is used in any of the following locations, provide sufficient shielding measures:

Print