Preparation Before Wiring (ICD-WLBT)
Set parameters such as the IP address and WLAN settings before wiring.
Requisite Devices
USB cable (USB Type-C connector (This unit side)): 1
Connection Diagram
Parameter settings can also be configured using power supplied via the USB port.* 1 (Bus power)
*1 USB cable (To be prepared by user)
*2 USB connection takes priority.
Be aware that other functions (Ethernet, Bluetooth, WLAN) will be disabled when connected via USB.
Be aware that other functions (Ethernet, Bluetooth, WLAN) will be disabled when connected via USB.
① | PC software | Wireless Device Parameter Setup Tool |
➁ | WLAN/Bluetooth Converter | Model: ICD-WLBT-* |
*1 Excluding WLAN access point search.
*2 When the USB is disconnected, other functions (Ethernet, Bluetooth, WLAN) will start operating.
Wireless Device Parameter Setup Tool
Start the wireless device parameter setup tool and configure the parameters.
For details of the setting parameters, refer to WLAN/Bluetooth Converter Parameters .
For details of the setting parameters, refer to WLAN/Bluetooth Converter Parameters .
After assigning an individual IP address to this unit, parameter configuration can be performed via a network connected through Ethernet or WLAN.