Step2 Wiring
The wiring procedure is shown below.
Refer to Startup, Installation, Wiring for details regarding pin assignment and how to perform wiring.
Refer to Startup, Installation, Wiring for details regarding pin assignment and how to perform wiring.
- When pulse motor equipped models is used
Pulse Motor Equipped Models Wiring - When 24V AC servomotor equipped models is used
24V AC Servomotor Equipped Models Wiring - When 200V AC servomotor equipped models is used
200V AC Servomotor Equipped Models wiring
Cable connector connection
Connect the power & I/O cable or Power & I/O Connector to the ELECYLINDER.
Join also the motor cable for the 200V AC servomotor.
Insert the connector until you hear the "click".
Join also the motor cable for the 200V AC servomotor.
Insert the connector until you hear the "click".
Connecting to power supply
In order to supply power, join ELECYLINDER to the 24V DC power supply.
For the 200V AC servomotor, join 100V AC or 200V AC to the control power supply and the motor power supply and connect the motor cable to PSA-200.
For the 200V AC servomotor, join 100V AC or 200V AC to the control power supply and the motor power supply and connect the motor cable to PSA-200.
Connecting to PLC
Connect the cable power & I/O cable terminal to the PLC.
