Frame Grounding Wiring
Slider Type
Make sure to perform grounding as shown in the figure below in order to prevent electric shock and electrostatic charge, to improve noise durability performance and to control unexpected radiation.
Use a tester to measure the continuity between the fixing screws and grounding surface to check whether it is grounded or not.
If slider type, Conduction can be checked in the area on the base bottom where no surface treatment is applied.
If slider type, Conduction can be checked in the area on the base bottom where no surface treatment is applied.
Belt Type
In order to for electric shock prevention, electrostatic charging prevention, to improve noise resistance performance and to control unnecessary radiation, make sure to certainly perform the grounding as shown in the figure below.
Grounding wires should not be connected in common with other devices and separate controllers should be grounded.
Use a tester to measure the continuity between the fixing screws and grounding surface to check whether it is grounded or not.
Conduction can be checked in the area on the base bottom where no surface treatment is applied.
Conduction can be checked in the area on the base bottom where no surface treatment is applied.
