Wiring Method (Pulse Motor Equipped Models)
Refer to the example of connection below to insert the connectors to ELECYLINDER and the EC connection unit.
Push the connectors inward till it makes "click" sound.
The axis number should be determined by the position of the connector on the EC connection unit.
Push the connectors inward till it makes "click" sound.
The axis number should be determined by the position of the connector on the EC connection unit.
Interface Separate Type Wiring (Connecting Directly to EC Connection Unit)
Connect the actuator cable to the EC connection unit (RCON-EC).
Caution
- There is an orientation for insertion to the connector.
Align the orientation to the profile of the connector and push in until it makes "click" sound.
Interface Separate Type Wiring (When Interface Box is used)
When connecting to an EC connection unit using an interface box, perform the wiring as shown in the figure below.
Caution
- There is an orientation for insertion to the connector.
Align the orientation to the profile of the connector and push in until it makes "click" sound.