Heat Radiation and Installation (DC Power Supply for Motor Drive)
The way to install the motor drive DC power supply should be by affixing with screws or on DIN rails.
(Note) Refer to External Dimensions for dimensions.
Install the unit vertically as shown in the figure below for orientation.
(Note) Refer to External Dimensions for dimensions.
Install the unit vertically as shown in the figure below for orientation.
Orientation of installation inside control panel
Follow the figure below for the minimum distance to a wall and the minimum distance to peripheral devices. Design and build the control panel considering the ambient temperature for use of this power supply unit falling into the temperature range from 0 degC to 55 degC at the installation place.
Restriction of ambient environment (PSA-200)