Frame Ground Wiring
The ELECYLINDER has a built-in controller circuit board.
The controller frame grounding line is connected to the ELECYLINDER body and through to ground via the ELECYLINDER mounting surface.
* The Ground wire, Grounding screw and the M3 square nut is to be prepared by the customer.
The controller frame grounding line is connected to the ELECYLINDER body and through to ground via the ELECYLINDER mounting surface.
* The Ground wire, Grounding screw and the M3 square nut is to be prepared by the customer.
When connecting to interface boxes
Connect the ground terminal on the conversion cable.
When connecting directly to RCON-EC
Ground the FG (frame grounding) on the gateway unit or SEL unit side.
* Annealed copper wire: 1.6 mm diameter Connect with a ground wire of (2mm2: AWG14)